Many love the look of a TV plasma wall hanging neatly. However, due to restrictions cables or wall construction, this is not always practical. Flat plasma requires a solid foundation to support its weight and add other equipment you want to mount underneath. One of the most popular methods of building support plasma is used threaded rods board MDF or rustic tv stands.
Cut the MDF shelves to the depth and breadth necessary to make a rustic tv stands. Based on the measured width full of components, speaker center channel or the base of plasma if you will not use other components. The depth is based on deeper component audio / video or twice the depth of the plasma at the minimum.
Paint or stain the shelves as you like for your rustic tv stands. Wait recommended by the manufacturer for healing times paint or stain interval. Drill a hole of 1 inch (2.5 cm) to 1 inch (2.5 cm) from the corner of each shelf after the layer has fully cured. Broken a nut, metal washer and rubber to 1/2 inch (1.2 cm) from the ends of four of the threaded rods. Slide the panel MDF shelf elected based on the four poles, with rubber washers in direct contact with the bottom of the shelf.